Geelong is a real part of our patch, not a postcode we service reluctantly. It also covers a lot of ground — three distinct housing eras, two different geologies, and a winter that affects when a floor can go down.
Floor shown is a visualisation — stock reference photography, not a completed Ironclad job.
Geelong is really several housing markets at once. Geelong West sold land from the 1840s and is overwhelmingly single-storey timber — Edwardian and Federation through to Californian bungalow — where the garage, if there is one, is a later structure at the rear on a much younger slab. Herne Hill is mainly post-war. Corio and Norlane are Housing Commission country: building started in 1947 and Norlane alone had 2,464 Commission houses by 1976, put up for the Ford, International Harvester and Shell workforces. A lot of those garages have been working workshops ever since.
Then there is Armstrong Creek, approved in 2010 and heading toward roughly 22,000 dwellings across Warralily, Harriott and Armstrong Village. It is over 95% separate houses and added close to four thousand of them between 2016 and 2021 — the region's biggest new garage market, and the one where slab age is the first question we ask.
The geology varies more than the map suggests. The council's own work on the northern growth area describes ground predominantly underlain by Newer Volcanic deposits, and states that shallow continuous bedrock and highly reactive, expansive soils act as constraints on building there. East of the city the Moolap country carries grey and black cracking clays over a shallow water table; to the west the Barrabool Hills are Cretaceous sandstone. We are not going to guess which of those is under your garage from the suburb name — we test the slab.
1900s period, post-war Housing Commission, or post-2010 Armstrong Creek. All three, all common.
Detached rear single in the old suburbs; standard 36 m² double in the growth corridor.
Old rear slabs with no membrane, hard-used post-war workshops, or new slabs still curing.
Same four stages on every job in Geelong, residential or commercial. No shortcuts, because we're the ones carrying the guarantee.
Diamond-ground back to bare, open concrete. Not acid-etched, not rolled over. Dust-extracted, so the garage stays clean.
Moisture tested before a drop goes down. Cracks and joints are cut out and filled so they don't telegraph through the finish.
Pigmented base coat, then decorative flake broadcast to refusal for full coverage, grip and depth. Your colour, chosen before we arrive.
Clear coat over the top, edges cut in sharp, site cleaned. You get the guarantee in writing before we leave.
One day on site. Walk on it after 24 hours, car back on it at 48. Gear moved and put back — you don't lift a thing. Written guarantee against lifting, and it transfers if you sell.
Geelong is about 75 km from the Melbourne CBD down the Princes Freeway, an hour in free-flowing traffic, and 43 km from Werribee — around half an hour, and it skips the West Gate entirely. We cover the Bellarine and the Surf Coast off the same trip: Ocean Grove, Barwon Heads, Torquay. There is no travel surcharge hidden in the quote.
The genuinely local factor is temperature. Geelong runs colder and damper than Melbourne's western suburbs, and resin systems have a minimum application temperature and a minimum substrate temperature below which they will not cure properly. On a cold, still Geelong morning in July an unheated garage slab can sit under that threshold well into the day. It does not stop us working through winter — it means we plan the start time and check the slab temperature rather than the air temperature, and occasionally it means moving a booking.
If you are on the Bellarine or the Surf Coast, say so when you enquire. It is the same trip for us, but the scheduling works better if we batch it.
We cover Geelong properly, along with the Bellarine and the Surf Coast. It is about an hour from the CBD on the Princes Freeway and around half that from Werribee, and the quote you get is the quote — no travel loading at the bottom.
Yes, with planning. Resin systems need the slab itself to be above a minimum temperature to cure properly, and a cold unheated Geelong garage can sit under that on a July morning. We check slab temperature rather than air temperature and set the start time around it. If conditions won't let the floor cure properly we move the day rather than laying it anyway.
It depends on when the slab was poured, not when you moved in. New concrete is generally left at least 28 days before coating, with the product data sheet having the final say, and we moisture test to confirm. Tell us the pour date and we will give you a straight answer on timing.
More general questions are answered on the main FAQ, and Melbourne-wide answers — cost, systems, timing — live on the epoxy flooring Melbourne page.
One photo and rough dimensions is all we need to give you a real number — no site visit required. Quotes weekdays 7am–7pm.
Get my price →